RP-RED 063 | Clean Water Leak Repair Chemical
RP-RED063 It is a product that provides a long-lasting solution with the feature of closing the leaks formed due to capillary cracks formed on the wet floor.
RP-RED063 It is a product that provides a long-lasting solution with the feature of closing the leaks formed due to capillary cracks formed on the wet floor.
AREAS OF USE
Our Clean Water Plumbing Leak Repair Chemical; It closes the leaks formed in PPRC, PVC, iron, copper and galvanized plumbing pipes by tracing crystals.
THINGS TO BE CONSIDERED BEFORE APPLICATION
When applying in the installation, the areas connected to the clean water installation such as boiler, water heater, washing machine, dishwasher, water purifier, special armatures and siphon used in the place where the leak is located should be disconnected. In cases where the application will not be made in the entire system, it is necessary to find out on which line there is leakage. Entering from the faucet and measuring with a manometer will provide more accurate results about the amount of leakage. Those who want to use plumbing cleaning machines for circulation should pay attention to the cleanliness of the machine and the absence of acidic residues. If acid residue remains, the reaction of the leakage chemical you will use in your machine will be delayed.
THINGS TO BE CONSIDERED DURING APPLICATION
In the clean water installation, a bypass should be made for circulation and the system should be made ready as a closed circuit. Then you need to inject the chemical that we have diluted in % measurements into the system with water pumps. You can easily do this process with plumbing cleaning machines if you wish. Circulation should be done in the installation for 24 hours at certain intervals. If the line where the leakage is found in the manometer measurement is a hot water installation, it is recommended that the circulation temperature be 60-70 degrees on average. Leakage is also eliminated when applied at minimum temperature. However, it should not be forgotten that hot water plastic pipes expand due to temperature. If it expands, the water leakage will be exposed again and our application will fail under these conditions. Clean water connections should never be used during the process.
THINGS TO BE CONSIDERED AFTER APPLICATION
Disconnect your connected pump or machine from the installation in order to create circulation in the installation. Drain the chemical in the installation by utilizing the mains pressure. If the pressure is high, it is recommended to install a pressure reducer in the installation system. Since our product does not leave any residue that will harm human health in the cleaned system, it can be started to use.
*These data are general information. It varies according to the ground to be applied.
